View cart “205 GTI Rubber Fuel Lines” has been added to your cart.
205 GTI Brake Servo Vacuum Pipe
Code: RH205-21-2
Direct replacement for the original.
Hose runs from: Side of inlet manifold to brake servo. On vacuum sunroof equipped cars there is a T-peice located near the brake servo. A short section of hose is supplied to replace this section if with sunroof is selected.
Designed to an OE style with the braided cotton outer covering.
Available for RHD and LHD configurations.
Supplied cut to length with our cobra clips for a neat installation.
This is the one bush which gets over looked when the engine mounts are uprated. The original bush is usually worn and allows unnecessary engine movement for race/rally/trackday setups.
Location: This bush is located within the fork which connects the subframe to the lower engine bush.
Suitable For:
Fits all 106 and 205 models incl. GTi
Direct replacement for original
For a more compliant version of the bush, take a look at the Grp.N version.
Our Rubber fuel lines are remanufactured so they are a direct replacement for standard hoses.
They are sold as a pair:
The short hose runs from the steel fuel line to the bottom of the fuel filter
The longer hose runs from the top of the fuel filter to the fuel rail
Both hoses come with new banjo bolts and crush washers.
Please note: We have changed the rubber spec to Gates SAE 30R14 T2 since June 2020. Using this rubber spec our rubber fuel lines are now compatible with E10 grade fuel. However, we would still advise customers to use E5 Super unleaded as there are other parts in the fuel system that may not be compatible with E10 unleaded.
These bronze bushes replace the standard plastic ones found in the gearstick pivot point. These will not flex or distort and therefore reduce play in the linkage system.
Notes: Ideally to be used with our 205 Gearchange Rods (3-rod kit) and 205 Bronze L-linkage Pivot Bush Kit, as well as Adjustable Quickshift.
This is the power steering cooling loop pipe which runs under the car on 205 GTI models equipped with PAS. The originals are prone to rust due to their location.
Using an original we have re-manufactured them using a CNC tube bender, then a custom jig has been made to manipulate the final bend. Using CNC technology ensures their complicated shape is repeatedly replicated accurately.