Direct replacement for the original.
Hose runs from: Side of inlet manifold to brake servo. On vacuum sunroof equipped cars there is a T-peice located near the brake servo. A short section of hose is supplied to replace this section if with sunroof is selected.
Designed to an OE style with the braided cotton outer covering.
Available for RHD and LHD configurations.
Supplied cut to length with our cobra clips for a neat installation.
£13.38 + VAT
In StockAdditional information
Weight | 0.4 kg |
---|---|
With or Without sunroof | With sunroof, Without sunroof |
Related products
-
205 / 309
205 Bronze L-linkage Pivot Bush Kit GTI
The original linkage setup consists of two plastic bushes and a spring washer, even when new this setup had a lot of unwanted play in it. The linkage will now more than likely be considerably worn, causing the linkage system to feel “sloppy”. There are other kits available which replace the plastic bushes with bronze equivalents but the spring washer design is still utilized, along with the original large shanked bolt.
Only by changing the design of the pivot system (by using this kit) can the sloop be reduced entirely.
Rated 5.00 out of 5(1 review)£31.03 + VAT Add to cart -
205 / 309
205 Torsion Bar End Stop
The torsion bar end stops screw into the rear axle beam tube. They act as a end stop for the torsion bar screw
They are a direct replacement for the standard item. Two are required per axle.
Note: Sold individually – increase quantity to buy more than one.
(0 reviews)£3.85 + VAT Add to cart -
205 / 309
205 GTI Fuel Line + P.A.S. Pipe Clips
Original Peugeot Clips. We have bought a large batch from Peugeot as they often need replacing when fitting our new fuel lines or P.A.S cooling loop pipe.
They are sold individually – please enter the desired quantity when ordering.
- 6x clips are needed to replace all the fuel lines under the car
- 4x Clips are needed to replace the P.A.S cooling loop (1.9 GTI models only)
(0 reviews)£2.25 + VAT Add to cart -
205 / 309
205 Bronze Gearstick Pivot Bushes Gti and Non Gti
Fitment: Suitable for the 205 Gti and Non Gti.
These bronze bushes replace the standard plastic ones found in the gearstick pivot point. These will not flex or distort and therefore reduce play in the linkage system.
Notes: Ideally to be used with our 205 Gearchange Rods (3-rod kit) and 205 Bronze L-linkage Pivot Bush Kit, as well as Adjustable Quickshift.
Sold in pairs as pictured
(0 reviews)£14.98 + VAT Add to cart