205 Gti Rear Valance Supports

Code: BW205-19

These offer support to the rear valance. Its very common for the originals to rust and break.

Our replacements are a direct fit and manufactured from 316 Stainless Steel.

Two per car required but can be ordered individually.

£5.89 + VAT

In Stock
Single or a pair
Product total
Options total
Grand total
Share (0)
Total: 0 Total: 0 Total: 0 Total: 0 Total: 0 Total: 0

Additional information

Weight 0.05 kg
Please select quantity:

,

Related products

  • 205 / 309

    205 Bronze L-linkage Pivot Bush Kit GTI

    The original linkage setup consists of two plastic bushes and a spring washer, even when new this setup had a lot of unwanted play in it. The linkage will now more than likely be considerably worn, causing the linkage system to feel “sloppy”. There are other kits available which replace the plastic bushes with bronze equivalents but the spring washer design is still utilized, along with the original large shanked bolt.

    Only by changing the design of the pivot system (by using this kit) can the sloop be reduced entirely.

    (1 review)
    £31.03 + VAT Add to cart
  • 205 / 309

    205 Torsion Bar End Stop

    The torsion bar end stops screw into the rear axle beam tube. They act as a end stop for the torsion bar screw

    They are a direct replacement for the standard item. Two are required per axle.

    Note: Sold individually – increase quantity to buy more than one.

    (0 reviews)
    £3.85 + VAT Add to cart
  • 205 / 309

    205 GTI Fuel Line + P.A.S. Pipe Clips

    Original Peugeot Clips. We have bought a large batch from Peugeot as they often need replacing when fitting our new fuel lines or P.A.S cooling loop pipe.

    They are sold individually – please enter the desired quantity when ordering.

    • 6x clips are needed to replace all the fuel lines under the car
    • 4x Clips are needed to replace the P.A.S cooling loop (1.9 GTI models only)

    (0 reviews)
    £2.25 + VAT Add to cart
  • 205 / 309

    205 / 106 Grp.A Lower Engine Fork Bush

    This is the one bush which gets over looked when the engine mounts are uprated. The original bush is usually worn and allows unnecessary engine movement for race/rally/trackday setups.

    Location: This bush is located within the fork which connects the subframe to the lower engine bush.

    Suitable For:

    • Fits all 106 and 205 models incl. GTi
    • Direct replacement for original

    For a more compliant version of the bush, take a look at the Grp.N version.

    (0 reviews)
    £20.87 + VAT Select options