These bronze bushes replace the standard plastic ones found in the gearstick pivot point. These will not flex or distort and therefore reduce play in the linkage system.
Notes: Ideally to be used with our 205 Gearchange Rods (3-rod kit) and 205 Bronze L-linkage Pivot Bush Kit, as well as Adjustable Quickshift.
Replaces standard rubber joints and mounts on all the mounting points of a rear beam.
Fitting this kit means the rear beam is rigidly attached to the chassis. Giving a more predictable rear end under heavy cornering and more control during lift off over steer.
Front flexible joints are replaced by acetal bushes (4 in the kit) while rear rubber “sandwich” mounts are replaced with “aircraft spec” quality aluminium blocks with offset studs (2 in the kit). This kit is an evolution and improved fit version of our original BBM-SA-R kit. Unlike standard items, our uprated items will not wear out!
This modification is a real benefit to a track orientated 205/309. It will also benefit a road car with respect to handling characteristics but at an expense of a slight increase in road noise experienced in the cabin.
These uprated rubbers replace standard soft rubbers in the shock absorbers top mounts, located just under strut turrets.
The rubbers are constructed to a very high standard using a rubber compound (with an increased Shore Rating over original), which is considerably firmer than the standard rubbers, making them far stiffer. They give firmer ride and less front suspension flex.
Joints in the original gearchange rod setup contain plastic bushes that wear over time, making the gearchange very unprecise and leading to rods popping off and leaving you stranded on a side of the road or track. Our rods are steel-jointed with securing clips that cures both issues.