Description
Re-manufactured items for a direct fit for the originals
2 needed per car
205 Gti Front Bumper Main Chassis Rail Mounts
Related products
-
205 / 309205 GTI Fuel Line + P.A.S. Pipe Clips
Original Peugeot Clips. We have bought a large batch from Peugeot as they often need replacing when fitting our new fuel lines or P.A.S cooling loop pipe.
They are sold individually – please enter the desired quantity when ordering.
- 6x clips are needed to replace all the fuel lines under the car
- 4x Clips are needed to replace the P.A.S cooling loop (1.9 GTI models only)
(0 reviews)£2.25 + VAT Add to cart -
205 / 309205 Grp.A Rear Beam Mount Kit
Replaces standard rubber joints and mounts on all the mounting points of a rear beam.
Fitting this kit means the rear beam is rigidly attached to the chassis. Giving a more predictable rear end under heavy cornering and more control during lift off over steer.
Front flexible joints are replaced by acetal bushes (4 in the kit) while rear rubber “sandwich” mounts are replaced with “aircraft spec” quality aluminium blocks with offset studs (2 in the kit). This kit is an evolution and improved fit version of our original BBM-SA-R kit. Unlike standard items, our uprated items will not wear out!
This modification is a real benefit to a track orientated 205/309. It will also benefit a road car with respect to handling characteristics but at an expense of a slight increase in road noise experienced in the cabin.
Suitable for: Peugeot 205 GTI and 309 GTI.
(0 reviews)£69.02 + VAT Add to cart -
205 / 309205 Torsion Bar End Stop
The torsion bar end stops screw into the rear axle beam tube. They act as a end stop for the torsion bar screw
They are a direct replacement for the standard item. Two are required per axle.
Note: Sold individually – increase quantity to buy more than one.
(0 reviews)£3.85 + VAT Add to cart -
205 / 309205 Bronze L-linkage Pivot Bush Kit GTI
The original linkage setup consists of two plastic bushes and a spring washer, even when new this setup had a lot of unwanted play in it. The linkage will now more than likely be considerably worn, causing the linkage system to feel “sloppy”. There are other kits available which replace the plastic bushes with bronze equivalents but the spring washer design is still utilized, along with the original large shanked bolt.
Only by changing the design of the pivot system (by using this kit) can the sloop be reduced entirely.
(1 review)£31.03 + VAT Add to cart