We have been a long term user of Wurth plastic trim dye.
It gives excerllent lasting results restoring colour to faded bumpers and side trims on the 205 Gti (as well as interior plastics).
We now stock the product and have it available in:
Contents :
*Solvent free product
Replaces standard rubber joints and mounts on all the mounting points of a rear beam.
Fitting this kit means the rear beam is rigidly attached to the chassis. Giving a more predictable rear end under heavy cornering and more control during lift off over steer.
Front flexible joints are replaced by acetal bushes (4 in the kit) while rear rubber “sandwich” mounts are replaced with “aircraft spec” quality aluminium blocks with offset studs (2 in the kit). This kit is an evolution and improved fit version of our original BBM-SA-R kit. Unlike standard items, our uprated items will not wear out!
This modification is a real benefit to a track orientated 205/309. It will also benefit a road car with respect to handling characteristics but at an expense of a slight increase in road noise experienced in the cabin.
Suitable for: Peugeot 205 GTI and 309 GTI.
Fitment: Suitable for the 205 Gti and Non Gti.
These bronze bushes replace the standard plastic ones found in the gearstick pivot point. These will not flex or distort and therefore reduce play in the linkage system.
Notes: Ideally to be used with our 205 Gearchange Rods (3-rod kit) and 205 Bronze L-linkage Pivot Bush Kit, as well as Adjustable Quickshift.
Sold in pairs as pictured
The offset washer is used to locate one end of the torsion bar into the trailing arm. These are prone to damage on removal.
They are a direct replacement for the standard item. Two are required per axle.
Note: Sold individually – increase quantity to buy more than one.
The original linkage setup consists of two plastic bushes and a spring washer, even when new this setup had a lot of unwanted play in it. The linkage will now more than likely be considerably worn, causing the linkage system to feel “sloppy”. There are other kits available which replace the plastic bushes with bronze equivalents but the spring washer design is still utilized, along with the original large shanked bolt.
Only by changing the design of the pivot system (by using this kit) can the sloop be reduced entirely.