205 Rear Quarter Badge Repair Kit

Code: BW205-1

The securing pins on the back of the rear quarter badges on the 205 Gti have always been a weak point.

BakerBM have designed a solution to the problem. They are made with a carbon blended plastic with a 12mm head with a cross formed in the back. The cross locates onto the ribbing of the badge ensuring the dowels are in the correct position. Having the cross formed into the part also increases the surface area for an adhesive to be affective. The badges can then be fitted as Peugeot intended.

 

£18.19 – £23.94 + VAT

In Stock
Share (0)
Total: 0 Total: 0 Total: 0 Total: 0 Total: 0 Total: 0

Description

There are 9 tabs needed to revive all 4 badges.

A panel adhesive will be affective at securing the pins.

 

 

In addition to this kit we can offer 9x rear quarter mounting bullets for £6.83 + VAT:

Additional information

Weight 0.1 kg
Please select option:

,

Related products

  • 205 / 309

    205 Torsion Bar End Stop

    The torsion bar end stops screw into the rear axle beam tube. They act as a end stop for the torsion bar screw

    They are a direct replacement for the standard item. Two are required per axle.

    Note: Sold individually – increase quantity to buy more than one.

    (0 reviews)
    £3.85 + VAT Add to cart
  • 205 / 309

    205 Grp.N Engine Mounting Kit

    EMB205-1 – Complete Group N (Grp.N) Engine Mounting Kit has been designed to substantially reduce engine movement by incorporating up-rated and stiffened rubber components. The kit is ideally used for rallying, racing, enhanced engine conversions and modifications.

    Contents of the kit also available individually.

    Available for: 205 1.6/1.9 GTI, 205 XS (please note when adding products to cart)

     

    (0 reviews)
    £105.40 + VAT Select options
  • 205 / 309

    205 Bronze L-linkage Pivot Bush Kit GTI

    The original linkage setup consists of two plastic bushes and a spring washer, even when new this setup had a lot of unwanted play in it. The linkage will now more than likely be considerably worn, causing the linkage system to feel “sloppy”. There are other kits available which replace the plastic bushes with bronze equivalents but the spring washer design is still utilized, along with the original large shanked bolt.

    Only by changing the design of the pivot system (by using this kit) can the sloop be reduced entirely.

    (1 review)
    £31.03 + VAT Add to cart
  • 205 / 309

    205 Offset Washer

    The offset washer is used to locate one end of the torsion bar into the trailing arm. These are prone to damage on removal.

    They are a direct replacement for the standard item. Two are required per axle.

    Note: Sold individually – increase quantity to buy more than one.

    (0 reviews)
    £1.18 + VAT Add to cart